Why is my invisible fence not working?
My pet’s Invisible Fence collar doesn’t activate at the boundary, what is wrong? Ensure that your pet’s Computer Collar receiver is fitted properly to his neck. The collar should be snug enough to slide only one finger between a correction post and your pet’s skin.
How do I reset my invisible fence?
Resetting the system can be as simple as replacing the batteries in your transmitter. Bring your dog inside, and turn off the power to the fence. Unplug the transmitter. Look for metal objects around or on top of the fence.
Why is my electric dog fence not working?
Check to make sure the collar battery is inserted positive end facing upward. Try resetting the frequency of your dog fence collars, to a setting of 01 on your transmitter. Try testing the collar by holding it at the height of your dog’s neck, which is around your knees.
How do you find a partial break in an invisible fence?
Plug in the Fence Transmitter and check the Loop Indicator Light. If the Loop Indicator Light is on you can assume the break is in the other half of the Boundary Wire. If the Loop Indicator Light did not come on and you hear a continuous beep, you may assume there is a break in this portion of the Boundary Wire.
How do you test if invisible fence is working?
Replace the Batteries Some invisible pet fences include a battery tester with the fence system. Place this on the collar and walk past the boundary wire. If the tester lights up and you hear the audible warning given by the collar, the battery is functioning properly.
How do I know if my petsafe transmitter is bad?
To check if the transmitter is having issues you’ll need to disconnect the existing boundary wire and connect a short 15-foot section of boundary wire to run some tests. Make sure the 15-foot wire is spread out. The signal will cancel anywhere the wire is within 3 feet of itself.
What does blinking green light mean on invisible fence?
When you first insert the battery into your receiver, the status light will flash green. This indicates that the receiver has started properly. In the event that the lights do not flash, check the battery to be sure that it has been inserted properly.
How do you check an invisible fence battery?
Insert the coin in the slot on top of the Power Cap unit and turn it 45 degrees counter-clockwise. Do not push down while turning. The Power Cap unit will rotate while the spring inside will push the Power Cap battery out of the Computer Collar unit battery chamber.
How do you find a bad spot in a dog fence?
Begin your visual check at the transmitter, where you first see the wire above ground. Walk around the dog fence wire, give it a tug, see if it has tension or if it is loose. Follow the wire around your property and look for areas where they may have been twisted or chopped. (It may be an internal break)
How do I check the battery in my invisible fence collar?
