What size Staples does a Stanley Bostitch bht150 take?

What size Staples does a Stanley Bostitch bht150 take?

Product Specs

How do you unjam a Stanley Hammer Tacker?

Here is the best way to do it:

1. Squeeze stapling end of hammer. tacker together, taking care to. avoid sharp staple.
2. Remove locking pin.
3. Press end clip in, then up.
4. Pull out spring assembly.
5. Remove staple channel.
6. Clear and reassemble.

How do you unjam a Bostitch hammer stapler?

Warning

1. Disconnect the construction stapler from the air supply. Use a hammer and punch to do this.
2. Push the driver upwards and past the jammed staple. Do this by putting the punch at the tip of the driver, which you should see coming out of the nose.
3. Tap the hammer against the punch and the jam should clear.

What size Staples does a Bostitch T5 stapler use?

7/16
Bostitch STCR2619 type staples, also known as Bostitch T5 staples. 7/16 Crown, 24 Gauge.

How do you clear a blocked stapler?

Hold the top of the stapler magazine with two fingers and slowly, while maintaining firm pressure, start pulling the lid apart from the part of the magazine that holds the staple. Be careful not to do this too quickly, or the lid might again fly open, spraying the staples all over your office or desk.

How do you open a Stanley Sharpshooter?

How to Load Staples Into the Stanley Sharpshooter Stapler

1. Release the loading latch at the end the stapler and pull the slide open.
2. Lay a stick of staples in the loading channel with the legs of the staples facing up.
3. Push the slide in until the loading latch clicks and catches.

How do you open a Stanley Bostitch stapler?

Standard Sized Stapler Basics According to the instructions from Bostitch, hold down the bottom of the stapler with your free hand. Pull the arm upward to open the hinge that holds it over the carrying tray. Push the arm back until the tension on the hinge is relieved and the carrying tray is fully exposed.