Is 8Cr13MoV better than 7Cr17MoV?
8Cr13MoV, as stated earlier, has about 0.8% carbon in the steel and 13% chromium. This means that, compared to something like 7Cr17MoV, it’s going to be a little bit tougher and hold a better edge, but it won’t have as good corrosion resistance. 8Cr13MoV is generally an all-around good budget steel.
Is 8Cr13MoV really that bad?
8cr13mov is clearly a great stainless steel for making knives. While it does suffer on edge retention, it performs really well in hardness and toughness, as well as corrosion resistance and ease of sharpening. Overall, it performs beyond expectations for a budget knife.
Is 8Cr13MoV hard to sharpen?
Since 8cr13mov has softer steel, it is easier to sharpen it. However, it will not maintain the sharpest edge most of the time.
Is 8Cr13MoV any good?
From our 8cr13mov discussion above, we can conclude that 8Cr13MoV steel is good steel for budget-minded knife users or for an entry knife. This steel offers proper hardness, wear resistance, corrosion resistance, and edge retention at a pocket-friendly cost.
What steel does Bubba blade use?
8CR13MOV stainless steel
All filleting knives from Bubba Blade are made from 8CR13MOV stainless steel, which is low- to mid-grade steel manufactured in China. The blades are Teflon coated and full tang in the handle.
What is the difference between 9cr18mov and 7Cr17MoV?
9Cr18MoV is also similar to 7Cr17MoV, but it has less hardness and more toughness. This gives it better edge retention and sharpening it wouldn’t be as easy as it’s the case with 7Cr17MoV. Both steels deliver great corrosion resistance.
Is 7Cr17MoV a good steel for knives?
Both 7Cr17Mov and 8Cr13Mov are used in Chinese-produced budget knives. Neither is considered a great blade steel. In my opinion, they both tend to be better than 3Cr13, 5Cr15Mov, and various mystery steels that get more popular the further below $20 you go.
What is 8Cr13MoV steel used for?
8Cr13MoV is a Chinese stainless steel grade but not listed in GB standard, it is customized by Chinese steel manufactures with reference to AUS-8 produced by a Japanese company called Aichi steel, the Rockwell hardness of 8Cr13MoV can reach above 62 HRC, so it is often used to make knife blades.
Is 8Cr13MoV really worth it?
While it isn’t all that wear resistant, or stainless for that matter, the ease with which it can be sharpened back to a good edge should not be underestimated. On the other hand, if you are used to S30V and the like, then I would think that 8Cr13MoV will be a step backwards for you.
