How do you reset the SRS light on a 2000 Honda Accord?

How do you reset the SRS light on a 2000 Honda Accord?

Reply Edit

1. Verify and make sure the ignition is switched OFF.
2. Connect the 2 pins in the MES with a paper clip or metal object.
3. Turn the ignition switch ON.
4. The SRS Indicator Light should come on for 6 seconds and then go off.
5. The SRS Indicator Light should come back on agian.
6. The SRS light should go off.

How do you reset the SRS light on a Honda Accord?

How to Reset a Honda Accord SRS Light

1. Straighten out a paperclip.
2. Pull down on the fuse panel cover under the steering column with your fingers to remove it.
3. Locate the small yellow plug in the fuse panel.
4. Unplug the power connector from the fuse panel.

What does SRS mean on a Honda Accord 2000?

The SRS light is a warning light for your supplemental restraint system (airbags). An SRS light means that there is a problem in the system. The first thing I would check is the fuse for the SRS unit.

How do you reset the SRS light on a 2000 Honda Odyssey?

Switch the ignition ON, the SRS light will appear for six seconds then OFF for four seconds. When the light goes OFF, REMOVE the paperclip. When the light comes ON, put the paperclip back IN. Once more, when the light goes OFF, REMOVE the paperclip.

How do you turn off SRS?

How to Reset an Airbag Light

1. Put the key into the ignition and turn the switch to the “on” position.
2. Watch for the airbag light to turn on. It will stay illuminated for seven seconds and then shut itself off. After it shuts off, immediately turn the switch off and wait three seconds.
3. Repeat Steps 1 and 2 two more times.

Where is the SRS fuse?

The fuse block is on the driver’s side of the engine compartment. Pull out the SRS fuse. In most models, this is fuse #40, located in the lower right corner of the fuse block.