How do I reset my Kenmore water heater?
To reset disconnect power for 30 seconds, then restore power and press the two temperature buttons, turn the thermostat to the on position, when all the led start to flash release the two temperature buttons within two seconds, then press again the two temperature buttons until all icons are on steady, release the two …
Why would pilot light go out?
Some of the possible serious reasons for pilot lights to go out include loose or broken gas valves, thermocouples or heat exchangers, faulty venting, low gas pressure, or high winds. If you believe there is a serious problem, don’t hesitate to contact a professional.
Why would a pilot light not stay lit on a water heater?
Thermocouple Issues If it senses that your water heater pilot light keeps going out, the thermocouple will shift off the gas supply to the heater. Over time, thermocouples can malfunction, accumulate dust buildup, or the device can get bent away from the pilot light’s flame.
How do you light a gas hot water heater with an igniter?
Turn the water heat dial to Low and the On/Off/Pilot dial to Pilot. Then, turn the On/Off/Pilot dial downwards and push the igniter button at the same time. Let go of the igniter button, but keep pressing the Pilot dial downward for around 30 seconds. You should hear a “whoosh” sound when the gas is lit.
How do you light a gas water heater with electronic pilot?
Turn the gas knob to “Pilot,” press and hold it down. This will start the flow of gas so you can light the flame. Some water heaters have a separate button for pilot mode, usually a red one, which you’ll press and hold. While still holding the gas down, light that pilot.
Why is my gas water heater not lighting?
If you have a natural or propane gas water heater, chances are the pilot has gone out. If the pilot doesn’t relight, if it goes out right after lighting or if it goes out repeatedly, by far the most common cause is a bad thermocouple.
How do you reset the pilot light?
Relight the pilot light. Turn the knob to “Pilot,” and let gas to flow to the pilot. Light a lighter or match, then push in the reset button. Hold your flame to the pilot light’s opening. Keep the reset switch depressed until the pilot light is burning steadily.
