How do I fix my DStv Explora error E48-32?

How do I fix my DStv Explora error E48-32?

The error is easily fixed by turning off the TV and leaving it off for a few seconds, and then turning it back on again. The main cause of the e48-32 error is the accumulated dust on the Dstv card, which causes the card to overheat and activate the unused component, which then deactivates after a while.

Why is my DStv showing E48-32?

Probably the most common DStv error code people experience is E48-32 together with the message “There is no signal. This may be due to bad weather or a faulty connection in the installation”.

How do I fix my DStv Explora signal?

How To Fix Signal Strength On DStv?

1. Check F-type connectors. Check for incorrectly connected F-type connectors on the LNB and at the back of the decoder.
2. Correct the LNB alignment.
3. Adjust satellite dish alignment.
4. Replace a faulty LNB.
5. Move your satellite dish.
6. Cut down or prune trees that may obstruct the signal.

How do you clear the error code on GOTV E48-32?

How to Clear Error Code on GOTV – E48-32 Error Message

1. Check if antenna is properly connected to decoder, if it isn’t, connect properly.
2. Tap on the OK button to see signal information.
3. Go to Menu>Advanced>Installation – click on Auto scan.

How do I clear E48 32 error on DStv Kenya?

To clear the E48-32 Error Press Menu on your remote control>Advanced options>Installation>Reset and update on the progress. Congratulations; you are done.

How do I clear E48-32 error on DStv Kenya?

How do I clear E37-32 on DStv?

Clear this error via the DStv App, on Self Service or using the DStv WhatsApp bot. Check if the correct smart card is inserted. E37-32 (Service does not exist.) Please re-boot and re-scan your decoder to get an updated service list.

How do I reset my DStv to factory settings?

Press the blue “DStv button” on your remote control. Then use the right arrow on the remote control to go to “Settings“. Use the down arrow to go to “System Settings“. Scroll down using the down arrow to select “Reset To Factory Default” then press “OK” on your remote control.